Guided test demo: a harness checked pin by pin
A test sequence walks you through a wiring harness one pin at a time. The readings here are made up; in the app they come from your own multimeter over Bluetooth.
Phone simulation: Guided test with pass and fail
About guided tests
A test sequence is a list of steps, each with what to measure and its limit. The app shows one step at a time, captures the reading by itself once it is stable, marks it PASS or FAIL and moves on. A failed step says what was wrong, here a reading above the 1 Ω limit.
The finished run becomes a test file with every step, value and verdict. The ten starter templates run as often as you like for free; building your own procedures is part of Pro.
On testnmeasure.app
- How test sequences with pass/fail work
- Guide: wire harness continuity test
- Guide: pass/fail procedures with any multimeter
- Guide: a pin table from a connector drawing
- See the supported OWON and ZOYI meters
- TestNMeasure on the App Store
iPhone and iPad (iOS 17 or later): free on the App Store. Android later.